Metal stamping parts processing plant assembly mold introduction

1. Put the mold handle into the upper mold base for later use;

2, put the punch into the fixed plate, and insert the punch into the fixed plate into the female mold to check whether the assembly is correct and check whether the gap is uniform;

3. Assemble the lower mold;

4. Put the die on the lower die seat and screw on the screw, but don’t screw it too tight;

5. Insert the cylindrical pin of the female mold and tighten the fastening screws

6. Put the guide plate on the die, screw on the screw but don’t screw it too tight;

7, install the cylindrical pin and tighten the fastening screw, and install the stopper pin;

8. Assemble the upper mold;

9. Place the lower mold flat on the worktable according to the working position, and put parallel pads on the edge of the hole on the concave mold;

10. Put the punch with the fixed plate, the backing plate and close the upper mold seat according to the signs;

11. Tighten the upper die fastening screws, but do not tighten them too tightly;

12. Open the upper mold, drive a cylindrical pin from the fixed plate in the direction of the upper mold base, tighten the fastening screws, and install the unloading plate;

13. Clamp the mold, and the entire mold assembly process ends;